This week I have been learning how to knit during my lesson at college. First I had to go through the health and safety for knitting to make sure I would not hurt myself or others. The first thing was to behave responsibly when using the equipment as someone could get injured, the second was to watch what you and others are doing so you don't trip over the wool or get stabbed with the needles.
Below is a image of the equipment I would be using:
Equipment
The equipment I would be using was two needles and a ball of wool. The wool could be any type as it did not matter. The needles I got were a size of 8.0 millimeters the size for this didn't matter either as I wasn't making a specific thing I was just learning the different stitching.
First for knitting I learnt how to Cast on. To start I tied a loop on my finger with the wool at the start of the ball and transferred it onto the left needle. Then I went through the bottom of the loop with the right needle and put that needle behind the left one to form a X. Then taking the wool I wrapped it around the right needle and then pulled the left needle through the original loop with the wool I just wrapped around the left needle with it. Then after pulling it through put it over the right needle and repeat with the top loop until you have the number of stitches you want.
I found this difficult at first but after I practiced this a few times I managed to cast on a row of stitches on my own. It is quite simple once you know what you are doing with the wool and how you need to hold the needles.
Below is a video of this process:
How to cast on beginner
Then I learnt how to do a knit stitch. First insert the left needle knitwize into the first loop on the right needle and put it behind it in a X. Then taking the wool wrap it around the left needle and through the X you have made. After this pull the left needle out of the loop taking the wool that has been wrapped around it and slide it over the left needle to make a loop and leave it there. Then pull the top loop off the right needle and repeat until you come to the end. Once you get to the end swap the needles over and continue the stitch until you are ready to finish.
This step was little complicated for me to get at first and I did end up adding stitches to some rows and taking some off. I ended up adding three stitches to my original twenty stitches but I have learnt from this by learning to count the stitches and wrap the wool around the needles the correct way.
Below is a video of this step:
How to knit stitch
Finally I had to learn how to cast off this I think was very easy to do and I managed to catch on quickly to the technique. First you have to knit two stitches, then put the left needle into the bottom stitch on the right needle and pull it up over the stitch on the top of the right needle. Continue to do this until you have one last stitch. Once on the last stitch cut the line of wool off from the ball leaving a small length and thread it through the final stitch. Then pull it tight and you will be finished with your knitted piece.
The casting off stage was one of the simple parts and it is great once you have finished and get to see your final piece of knitting.
Below is a video of casting off:
Cast off
I thoroughly enjoyed my first lesson of knitting and have learnt a lot from my first attempt. My first sample of knitting doesn't look as good and tight as it could as I didn't have much tension in my wool. It isn't a big sample as I started off knitting slowly and didn't know how to hold the needles properly but it is a good experimental piece.
My knitting piece
During this lesson I also learnt how to do a purl stitch this extended my skills for knitting but that will be going on my next blog so please read it. Until then goodbye x
No comments:
Post a Comment